Cylinder Liner - Remove
`
3500 Engines
[RENR9365]
3500 Engines
Electronic Control Module (Engine) - Remove and Install
3500 Engines
Connecting Rod Bearings - Remove and Install
BASIC ENGINE
CYLINDER BLOCK GP
3408E and 3412E Engines for Caterpillar Built Machines
Bearing Clearance - Check
3508C, 3512C and 3516C Marine Engines
Camshaft Bearings - Remove
3508C, 3512C and 3516C Marine Engines
Camshaft Bearings - Install
3500 Engines
Cylinder Liner - Remove
3500 Engines
Connecting Rod Bearings - Remove and Install
3508C, 3512C and 3516C Marine Engines
Crankshaft Main Bearings - Install
3508C, 3512C and 3516C Marine Engines
Crankshaft Main Bearings - Remove
1.1. Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 5P-8665 | Cylinder Liner Puller | 1 |
Start By:
- Remove the pistons and the connecting rod assemblies. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) to remove cylinder liner (1).
Show/hide table
Illustration 2 g01004993 - Remove O-ring seals (3) and filler band (2) from cylinder liner (1).
Show/hide table
| |
| Illustration 1 | g01120797 |
Information System:
2004/11/01
Improved Mounting of the Power Distribution Box {7426}
365B Excavators Hydraulic System
Swing Bearing Movement - Measure
C11 and C13 Engines for Caterpillar Built Machines
Throttle Switch Circuit - Test
C-10 Petroleum Engine
Air Inlet and Exhaust System
345B Excavator Hydraulic System
Swing Bearing Movement - Measure
3412E Petroleum Engine
Flywheel Housing
C11 and C13 Engines for Caterpillar Built Machines
User Defined Shutdown Input Circuit - Test
3508B, 3512B and 3516B Generator Set Engines
Cylinder Head - Remove
12M, 140M, 160M, 140, 150 and 160 Motor Graders Braking and Hydraulic Fan System
Valve Replacement Kit - Diverter Valve and Relief Valve
320B Excavator Hydraulic System
Swing Bearing Movement - Measure
C11 and C13 Engines for Caterpillar Built Machines
Engine Temperature Sensor Open or Short Circuit - Test
C12 Marine Engines
Auxiliary Water Pump - Assemble
3512B and 3516B Engines
Cylinder Liner - Install
2004/11/01
Circuit Breakers - Steps to Consider When Resetting {1420}
G3524 and G3532 Tandem Maintenance{7002}
3600 to 3600 Electronic Unit Injector (EUI) Upgrade{1000, 1250}
C-10 Petroleum Engine
Cooling System
C-10 Petroleum Engine
Finding Top Center Position for No. 1 Piston
C-10 Petroleum Engine
Fuel System - Prime
3412E Petroleum Engine
Finding Top Center Position for No. 1 Piston
325D and 329D Excavators
Hydraulic System Oil Level - Check
C-10 Petroleum Engine
Inlet Manifold Pressure - Test
325D and 329D Excavators
Hydraulic System Oil Filter (Return) - Replace
C-10 Petroleum Engine
Cooling System - Check - Overheating