C11 and C13 Engines for Caterpillar Built Machines System Configuration Parameters Caterpillar

System Configuration Parameters

C11 and C13 Engines for Caterpillar Built Machines [RENR5092]

C11 and C13 Engines for Caterpillar Built Machines Sensors and Electrical Connectors

C11 and C13 Engines for Caterpillar Built Machines 5 Volt Engine Pressure Sensor Supply Circuit - Test

ELECTRICAL AND STARTING SYSTEM

ELECTRONICS GP-ENGINE

C15 and C18 Petrolem Generator Set Engines System Overview

C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Electronic Service Tool Will Not Communicate with ECM

C11 and C13 Engines for Caterpillar Built Machines Event Codes

1.1. "Equipment ID"

2.1. "Engine Serial Number"

3.1. "(FLS)" Full Load Setting

4.1. "(FTS)" Full Torque Setting

5.1. Parameter Table

6.1. Parameter Worksheet

System configuration parameters are parameters that affect emissions, power of the engine, and machine applications. Default values for the parameters are programmed at the factory. Some parameters may be changed by the customer in order to suit the needs of the specific application. You must reprogram the system configuration parameters if the Electronic Control Module (ECM) is replaced and/or you reprogram the engine rating. You do not need to reprogram the system configuration parameters if you replace the flash file. Proper values for these parameters are available on AVSpare Electronic Technician (ET). Certain configuration parameters are also stamped on the engine information plate.

Note: If the parameters that are protected with the factory passwords are changed, the AVSpare warranty may be voided.

"Equipment ID"

The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field.

"Engine Serial Number"

Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM.

"(FLS)" Full Load Setting

"Full Load Setting" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required.

"(FTS)" Full Torque Setting

"Full Torque Setting" is similar to "Full Load Setting". Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required.

Parameter Table

Show/hide table

Table 1
System Configuration Parameters
Parameter	Available Range or Options	Default	Required Password
"Equipment ID"	17 characters	blank	none
"Engine Serial Number"	8 characters	blank	Factory
"FLS"	-128 to +127	0	Factory
"FTS"	-128 to +127	0	Factory

Parameter Worksheet

Record the following information before you change any programmable parameter.

Show/hide table

Table 2
Engine Parameters
"Equipment ID"
"Engine Serial Number"
"ECM Serial Number"
"Software Group Part Number"
"Software Group Release Date"
"FLS"
"FTS"
"Total Tattletale"

Show/hide table

Table 3
Information From Engine Information Plate
Engine Serial Number
Full Load Setting (for new ECM)
Full Torque Setting (for new ECM)

Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the AVSpare warranty.

Show/hide table