Procedure to Return the Fuel Filter for Certain Caterpillar Equipment{1260, 1261, 1274} Caterpillar


`
Procedure to Return the Fuel Filter for Certain Caterpillar Equipment{1260, 1261, 1274} [TIBU7272]
FUEL SYSTEM
FILTER GP-FUEL
Procedure to Return the Fuel Filter for Certain Caterpillar Equipment{1260, 1261, 1274}
1.1. Introduction
2.1. Problem
3.1. Solution
4.1. Packaging
Asphalt Paver:
AP1000E (S/N: T1F1-UP)
Backhoe Loader:
420F (S/N: JWJ1-UP)
Industrial Engine:
C7.1 (S/N: 7701-UP)
Excavator:
312E (S/N: WEY1-UP)
316E (S/N: DZW1-UP)
320E (S/N: WBK1-UP; PNL1-UP; TFX1-UP)
323E (S/N: RAP1-UP)
324E (S/N: TLF1-UP; LDG1-UP; PNW1-UP)
329E (S/N: RLD1-UP; TST1-UP; PLW1-UP)
Wheel Feller Buncher:
563C (S/N: JCB1-UP)
573C (S/N: RJT1-UP)
Motor Grader:
120M Series 2 (S/N: M9C1-UP; R9N1-UP)
Telehandler:
TH407C (S/N: MLH1-UP)
TL1255C (S/N: DHW1-UP)
Track-Type Tractor:
D5K Series 2 (S/N: KWW1-UP)
D6N (S/N: PBA1-UP)
Wheel Loader:
924K (S/N: PWR1-UP)
938K (S/N: SWL1-UP)
950K (S/N: R4A1-UP)
962K (S/N: T6A1-UP)

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem

If you are requested to return the 363-4364 Fuel Filter and the 384-8512 Fuel Filter , follow the procedure in order to return the fuel filter.

Solution

Remove the fuel filter as normal but ensure that the fuel is drained out of the outlet side of the screen. If possible, capture the fuel and send the fuel with the screen if this will not delay the shipping of the fuel filter. Shipping the fuel is not essential.

Packaging

Drain as much fuel out of the fuel filter as possible without shaking the fuel filter or disturbing the debris in the fuel filter

Cap both ends of the screen. Use the caps that were removed from the new fuel filter. Seal in a clean plastic bag and wrap in at least two layers of bubble wrap. Pack the fuel filter securely in a box so that the screen is not free to move around. Fill out as much of the checklist as possible and put the checklist in box with the fuel filter.

Send to:

FAO: Malcolm Pearson
Parts Return Centre
Maildrop 124
Perkins Engines Company Limited
Eastfield
Peterborough
PE1 5FQ
United Kingdom



Illustration 1g03452197

The fuel filter has the flow direction engraved into it

(1) Inlet (large dia)

(2) Outlet (small dia)




Illustration 2g03440298

Information System:

2013/10/21 Improved Case Assembly is Used on Certain CX31-P600 Petroleum Transmissions {3064}
C4.4 Engines for Caterpillar Built Machines Crankshaft - Spheroidal Graphite Iron (SGI) Crankshaft
440-0842 Major Engine Overhaul Foundational Kit for 3512 Engines{1000}
12M Series 3, 140M Series 3, 160M Series 3, 140, 150 and 160 Motor Graders System Schematic
2013/10/31 A New Pump Bracket is Now Used on Certain C12 Marine Engines Equipped with a Bronze Impeller Pump {1371}
2013/10/28 New Engine Software Is Used for Certain C280 Marine Engines {1901, 1920}
14L Motor Grader Machine Systems Bank Valve - Install - Rear Frame
14L Motor Grader Machine Systems Bank Valve - Disassemble - Rear Frame
14L Motor Grader Machine Systems Bank Valve - Assemble - Rear Frame
440-0216 Major Engine Overhaul Foundational Kit for 3512B and 3512C Engines{1000}
2013/10/03 The Hydraulic Tank Relief Valve Assembly Has Been Improved on Certain Cat Machines {4332, 4332, 5056, 5056, 5057, 5118}
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit General Information
C15 and C18 On-Highway Engines Exhaust Sensor Lines - Remove and Install - Exhaust Gas Venturi
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Alarm - Test
374F Excavator Machine Systems Hydraulic System Warm-Up
440-0928 Major Engine Overhaul Foundational Kit for 3512C Engines{1000}
C15 and C18 On-Highway Engines Nozzle Heater Harness - Remove and Install
C9 Engine Maintenance Interval Schedule
390F Excavator Counterweight Removal and Installation
2013/12/12 New Exhaust Shield Assemblies Are Used on Certain 3408 and 3412 Engines {1107}
131-5051 Dataview Group and Dataview Portable Tech Station Group{0374, 0599, 0701, 0709}
374F and 390F Excavators and 390F MHPU Mobile Hydraulic Power Unit Connector Contact Description
PM820, PM822, and PM825 Cold Planer Rotor Drive (Planetary) Oil Sample - Obtain
CX31-P600 Petroleum Transmission Transmission Cooling System