CX31 and CX31 HT On-Highway Transmissions Oil Filter (Transmission) - Replace Caterpillar

Filter Cartridge

Show/hide table

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.

Show/hide table

NOTICE
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates.

Show/hide table

Illustration 1	g03446477
(1) Filter base (2) Filter housing (3) Filter drain plug

1. Remove filter drain plug (3). Allow the oil to drain into a suitable container. Replace filter drain plug (3). Tighten to 18 ± 3.5 N·m (13 ± 3 lb ft).

2. Remove oil filter housing (2). Discard the used oil filter element that is inside of housing (2). Additional oil will drain when you remove the filter. Allow the oil to drain into a suitable container.

3. Inspect the seal on the housing (2). If the seal is damaged, replace the seal with a new seal.

4. Install the new oil filter element in the housing (2).

5. Install housing (2) and the new element into filter base (1). Tighten the housing 55 ± 5 N·m (41 ± 4 lb ft). Do not use an air wrench to tighten.

6. Make sure that the transmission is in NEUTRAL. Start the engine and operate the engine at low idle. Check for any leaks and make the necessary repairs.
   Show/hide table

   Illustration 2	g03446496
   (4) Filler tube

7. Observe the oil level (4) when the oil is warm and the transmission is in the NEUTRAL position. Make sure that the parking brake is engaged.

8. Stop the engine. If necessary, add oil.