A New Remanufactured Part is Now Available for Certain Cat<SUP>®</SUP> Engines {1000, 7754}
[M0123916]
BASIC ENGINE
ENGINE GP
A New Remanufactured Part is Now Available for Certain Cat</SUP> Engines {1000, 7754}
- Industrial Engine
- C13 INDUSTRIAL (S/N: RRA1-UP; LGK1-UP)
- C15 IND (S/N: JRE1-UP; MCW1-UP)
- C18 INDUSTRIAL (S/N: WJH1-UP; WRH1-UP)
- C15 IND (S/N: JRE1-UP; MCW1-UP)
Show/hide table
 |
|
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. |
The new C13 Industrial engine configurations include a piston change which allows better coverage. C15 and C18 Reman industrial engines are now built with Tier 4 blocks, allowing forward and backward compatibility.
The new and former part numbers are listed in Table 1.
Show/hide table
| Required Parts | ||||
|---|---|---|---|---|
| Qty | New Part Number | Former Part Number(1) | Model | Prefix |
| 1 | C13 | S/N:LGK and RRA | ||
| 1 | C13 | S/N:LGK and RRA | ||
| 1 | C15 | S/N:JRE and MCW | ||
| 1 | C15 | S/N:JRE and MCW | ||
| 1 | C15 | S/N:JRE and MCW | ||
| 1 | C18 | S/N:WJH and WRH | ||
| 1 | C18 | S/N:WJH and WRH | ||
Show/hide table
| (1) | The former part number listed is for reference only and may differ. |
Information System:
Cab Avoidance Function may Not Activate When Equipped with Narrow Work Tool on Certain 313 and 315 Excavators {7490}
Payload Calibration When Equipped with Narrow Bucket/Work Tool May Fail on Certain 313 to 352 Excavators {6001, 6101, 6502, 7490, 7494, 7610, 7620}
320 GC & 323 GC Excavator
Engine Starting
336 Excavator
Engine Oil and Filter - Change
777E Prime Off-Highway Truck Systems
Cylinder Mounting - Suspension
320 GX and 323 GX Excavator Systems
Check Valve (Return Makeup)
Fuel Correction Factor Calculation Procedure for Certain C32 Generator Set Engines with <NOBR>598-7998</NOBR> Engine Software {1250, 1280, 1900, 1901, 1920}
Cat</SUP> Command for Excavating, Remote Control Operator Console for Excavators
Electrical Connector - Inspect
G3500 Engines
Electronic Control Module (ECM)
777E Prime Off-Highway Truck Systems
Wiring - Cab
320, 320 GC, 323 and 323 GC Excavator Machine Systems Specifications
Front Lines
320 GX and 323 GX Excavator Machine Systems Troubleshooting
Connector Contact Description
320 GX and 323 GX Excavator Systems
Main Hydraulic Pump
320 GX and 323 GX Excavator Systems
Pump Control (Main Hydraulic) - Main Pump Regulator
320 GX and 323 GX Excavator Systems
Relief Valve (Crossover) - Test and Adjust
320 GX and 323 GX Excavator Machine Systems Troubleshooting
Relay - Test
320 GX and 323 GX Excavator Systems
Travel Motor - Test - Measurement of Case Drain Oil
320 GX and 323 GX Excavator Machine Systems Troubleshooting
Sensor Signal (Analog, Passive) - Test
336 Excavator
Sound Information and Vibration Information
336 Excavator
Plate Locations and Film Locations
A New Oil Lines Group, Filter Support Group, and Front Cover Fastener Group Are Now Used on Certain C175-20 Engines {1261, 1307}
C9 Marine Engines and Marine Generator Sets
Crankcase Breather
320 GC Excavator
Fuel System Primary Filter (Water Separator) Element - Replace
C9 Marine Engines and Marine Generator Sets
Engine Oil Pan